FINAL DRIVE
7.27
3. Remove the shim, thrust button, and thrust button
shim from the gearcase.
Thrust Button
Shims
4. Remove rear bevel gear from the gearcase
housing. cover.
5. Inspect the ring gear for abnormal wear, broken,
or chipped teeth. Spin the bearing to check the
ball bearings for smoothness. Replace the
bearing if needed.
6. Remove the input shaft cover and the pinion shaft
from the gearcase housing. See next page.
7. Inspect the ring gear for abnormal wear, broken,
or chipped teeth. Spin the bearing to check the
ball bearings for smoothness. Replace the
bearing if needed.
To Next Page
Loading...
