ELECTRICAL
10.9
SPEEDOMETER INSTALLATION
1. Spray a soap and water mixture onto the outer
surface area of the instrument cluster. This will
help the instrument cluster slide into the pod
assembly more easily.
2. Be sure the rubber grommet inside the pod is fully
installed and that the indexing key is in the
headlight pod keyway.
Align Index Points
3. Hold the pod assembly securely and insert the
instrument cluster into the pod assembly. Twist
the instrument cluster gently in a clockwise
motion to properly seat the instrument cluster into
the pod assembly. Apply pressure on the bezel
while pressing down on the instrument cluster.
NOTE: Do not allow alcohol or petroleum products to
come in contact with the instrument cluster lens.
To Next Page
Loading...
