ELECTRICAL
10.33
HEADLIGHT HOUSING
REPLACEMENT
1. Remove three Phillips screws on the headlight
pod.
2. Disconnect instrument cluster harness (A) and
winch selection switch (B).
A
B
3. Unplug headlamp harness (C).
C
4. Remove O-Ring (D) from headlight pivot pins.
(Both Sides)
D
5. Pull the headlight housing up to release from the
locking tabs.
Both Sides
6. Lift the adjusting knob up to remove from the
locking tabs.
7. Carefully pull the assembly up and out of pod.
8. Reverse the steps to install the new housing and
reassemble the pod.
51/8″
(13 cm)
NOTE: The distance from the headlamp parting line
to the end of the adjustment knob stop is 5 1/8, (13
cm). See illustration.
9. Adjust the headlight aim by turning the adjusting
knob.
To Next Page
Loading...
