ENGINE
3.11
600 ENGINE SERVICE DATA
Cylinder / Piston / Connecting Rod Engine No. -- EH590ALOE
Cylinder
Surface warpage limit (mating with cyl-
inder head)
0.004” (0.10 mm)
Cylinder bore Std 3.0118” (76.5mm)
Taper limit 0.00031” (0.008 mm)
Out of round limit 0.00030” (0.0075 mm)
Piston clearance
Limit .0022” ± .00067” (.055 ± .017 mm)
Boring limit N/A
Lifter
Outer Diameter Std 0.84245” ± 0.00025” (21.39 8± 0.00635 mm)
Block Bore Std 0.8438” ± 0.00062”(21.4322 ± 0.0157 mm)
Piston
Std 3.0096” ± .00035I (76.445 ± .009 mm)
Standard inner diameter of piston pin
bore
0.78757” ± .00098I (20.0045 ± 0.0025 mm)
Piston Pin
Outer diameter 0.7874” -- .7872” (20 -- 19.995 mm)
Standard clearance-piston pin to pin
bore
0.00027” ± 0.00019” (0.007 ± 0.005 mm)
Degree of fit Piston pin must be a push (by hand) fit at 68°
F(20° C)
Piston Piston rin
installed To
rin
Ring
gap
Limit 0.01181” ± 0.00393” (0.30 ± 0.10 mm)
Second
ring
Limit 0.01476” ± 0.00492” (0.375 ± 0.125 mm)
Oil rin
Limit 0.00984” ± .00393” (0.25 ± 0.10 mm)
Standard clearance To
rin
-
Limit 0.0019” ± 0.00069” (0.0475 ± 0.0175 mm)
piston ring to ring
Second
groove
ring
Limit 0.0017” ± 0.00049I (0.0425 ± 0.0125 mm)
Connect-
Connecting rod small end ID .789” -- .78841”. (20.030 -- 20.015 mm)
ing Rod
Connecting rod small end ra-
Std 0.00098” ± 0.00039” (0.025 ± 0.010 mm)
dial clearance
Connectin
rod bi
end side
clearance
Limit 0.01181” ± 0.00591” (0.30 ± 0.15 mm)
Connectin
rod bi
end radial
clearance
Limit 0.00015” ± 0.00006” (0.0038 ± 0.0015 mm)
Crankshaft Crankshaft runout limit 0.00236” (0.060 mm)
KEY - Std: Standard; OS: Oversize; ID: Inner Diameter; OD: Outer Diameter; Mag: Magneto Side;
PTO: Power Take Off Side