5.12
ENGINE
Piston / Connecting Rod
Place circlip
1. Torque bolts to 24 lb-ft (33 Nm)
2. Tighten bolts an additional 60
°
120 mm
Paint tolerance mark (see text)
gap at top
Install NEW rod bolts if disassembled
Match stamp on rod and cap.
or rear of engine
Rod stamp can face front
(Rod has no offset)
or bottom
NOTE: Pistons can be installed in either
orientation as they are symmetric.
PartShark.com
877-999-5686
To Next Page
Loading...
