12.18
ELECTRICAL
LIGHTS
Headlight Adjustment
The headlight beam is adjustable.
1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall.
2. Place the transmission in neutral and lock the parking
brake.
3. Measure the distance from the floor to the center of the
headlight and make a mark on the wall at the same height.
NOTE: Rider weight must be included on the seat
while performing this procedure.
4. Start the engine and turn the headlight switch to high beam.
5. Observe the headlight aim on the wall. The most intense
part of the headlight beam should be aimed 2 in. (5 cm)
below the mark placed on the wall in Step 3.
6. Loosen the adjustment screw at the rear of the headlamp.
7. Adjust the beam to desired position. Repeat the procedure
to adjust the other headlight.
Bumper Lamp Adjustment
1. Loosen the Phillips screw located at the rear of the lamp.
2. Tilt the lamp upward or downward.
3. Tighten the screw.
2 in.
25 ft.
(7.6 m)
(5 cm)
ADJUSTMENT SCREW
WARNING
Due to the nature of ATVs and where they are operated,
headlight lenses become dirty. Frequent washing is
necessary to maintain lighting quality. Riding with poor
lighting can result in severe injury or death.
PartShark.com
877-999-5686
To Next Page
Loading...
