12.9
ELECTRICAL
12
Instrument Cluster Pinouts
NOTE: Some functions not found on all models.
IGNITION SWITCH
Function Test
Use a multimeter to test for continuity between the 3 sets of
ignition switch outputs (OFF / ON / START).
Turn the key to ON. There should be continuity between pins C
and D / A and F.
Turn the key to START. There should be continuity between
pins A and B / C and D.
If any of the tests fail, replace ignition switch assembly.
Instrument Cluster Pinouts
FUNCTION PIN
Battery Voltage (Vdc) 1
Ground 2
Run / Stop Switch 3
CAN High 4
CAN Low 5
High Beam Input 20
Fuel Level Sensor 23
International Models Only
Hazard Warning 10
Left Turn Signal 21
Right Turn Signal 22
Ignition Switch Test
ABCDEF
OFF
ON
START
PartShark.com
877-999-5686
To Next Page
Loading...
