10.19
STEERING / SUSPENSION
10
Linkage Removal / Installation
1. Elevate rear of vehicle and safely support machine under
the frame area.
2. Remove the (4) wheel nuts and remove the rear wheel.
3. Remove the upper linkage bushing.
4. Remove the lower linkage fastener and remove the
stabilizer linkage.
5. Reverse this procedure to reinstall the stabilizer linkage.
Refer to the “REAR STABILIZER BAR - Exploded View”
for torque values.
Stabilizer Bar Removal / Installation
1. Remove the (2) exhaust springs from the rear portion of the
exhaust silencer.
2. Remove the (2) exhaust springs that retain the exhaust pipe
to the silencer.
3. Remove the exhaust silencer from the vehicle through the
right rear wheel well.
NOTE: Lift upward slightly on the exhaust pipe to
allow for enough clearance to remove the silencer.
4. Remove the (4) screws retaining the exhaust heat shield and
remove the shield from the chassis.
CAUTION
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Always wear eye protection.
Upper
Bushing
Lower
Fastener
Linkage
Heat
Shield
PartShark.com
877-999-5686
To Next Page
Loading...
