5.23
ENGINE
5
16. Remove the (4) screws retaining the engine skid plate and
remove the plate from the vehicle.
17. Place a drain pan under the front portion of the engine.
18. Slide the clamp back and remove the coolant inlet hose
from the water pump housing.
19. Slowly drain the coolant into the drain pan. Dispose of used
coolant properly.
20. Disconnect the stator and CPS wire harnesses.
21. Use the Roll Pin Removal Tool (PN 2872608), to drive out
the roll pin from the front propshaft. Pull the shaft back
towards the transmission to remove it from the front
gearcase input shaft, then pull it forward to remove it from
the transmission output shaft.
22. Remove all bolts from both sides retaining the engine to the
transmission.
23. Remove the top bolt from the RH engine isolator mount.
Coolant
Inlet Hose
Drain
HERE
Stator
CPS
Roll Pin
PN 2872608
Torque bolts to:
18 ft. lbs. (24 Nm)
36 ft. lbs.
(49 Nm)
PartShark.com
877-999-5686
To Next Page
Loading...
