12.6
ELECTRICAL
Speed Information
The top section of the instrument cluster is dedicated to
displaying either vehicle speed or engine RPM.
1. Select N or P gear position. Function will not work through
REVERSE OVERRIDE button when reverse gear is
selected.
2. Press and release the MODE button on the instrument
cluster or press and hold the LH control REVERSE
OVERRIDE button for more than 1/2 second to toggle
between vehicle speed and engine RPM displays.
NOTE: Mode button on instrument cluster is locked
out when vehicle speed is above 15 MPH.
Information Display Area
The center of the LCD is the information display area.
Information displayed in this area includes: Odometer,
tripmeter 1 / tripmeter 2, engine hours, service interval, engine
Diagnostic Trouble Codes (DTCs), and power steering DTCs.
1. Press and release the SELECT button on the instrument
cluster or press and release the LH control REVERSE
OVERRIDE button to toggle between the information
displays.
NOTE: DTC display modes can only be accessed
using the SELECT button on the instrument cluster.
Select button on instrument cluster is locked out
when vehicle speed is above 15 MPH.
Odometer
Trip Meters 1 and 2
The trip meters record the miles traveled by the ATV on each
trip. To reset a particular trip meter:
1. Toggle the SELECT button to either TRIP1 or TRIP2.
2. To reset to 0, push and hold the MODE button until the
distance display changes to 0.
Engine Hours
PartShark.com
877-999-5686
To Next Page
Loading...
