A device may pair automatically after connecting to the network. However, you may need to manually
pair a device in the following situations:
● The device doesn’t automatically pair during setup with the system that you purchased.
● You want to pair the device with a different system.
● You want to pair additional devices to control the video system with more than one TC8.
1. Connect the Poly TC8 that you want to pair to an Ethernet port in the room.
2. In the system web interface, go to General Settings > Device Management.
3. Under Available Devices, find the device by its MAC address such as 00e0db4cf0be and select
Pair.
If paired successfully, the device displays under Connected Devices with a Connected status. If
a device shows a Disconnected status, the pairing wasn’t successful.
If pairing isn’t successful, check the network connection and the configuration of both the Poly TC8
and the system you want to pair it with.
SCEP support on Poly touch controllers
You can manage certificates using your touch controller.
SCEP enables you to automatically enroll devices to retrieve new digital certificates or renew expiring
certificates. When paired to a Poly video system, your touch controller syncs settings automatically
from your Poly G7500 system or Poly Studio X video bar.
Configure or pair the touch controller in a staged network before moving to an 802.1x enabled
network.
● Settings can't be configured via the touch controller. SCEP and 802.1x settings are read-only.
● The touch controller syncs all SCEP and 802.1x settings from the primary device.
● Settings can either be set in the system web interface or provisioned via Poly Lens.
NOTE: Only HTTP SCEP server URLs are currently supported. Your SCEP challenge password
must be configured as a static password. Only a single set of credentials is shared between the Poly
G7500 system or Poly Studio X video bar and the Poly touch controller.
SCEP support on Poly touch controllers
13
To Next Page
Loading...
Need help?
General
