Polycom RSS 2000 User Guide
4-3
After an endpoint calls an RSS 2000 and makes a connection, videos will be listed for
playback only when the endpoint has viewing rights and its video algorithm supports
the video. If the endpoint does not support the video algorithm, a video will not be
shown on the Archive List even if the endpoint has viewing rights.
Quick Access Codes for Archive Playback
The user can use the quick access code to retrieve a recording file stored on a
device. The system automatically generates a quick access code for each file
after ending a recording. Users can find a file's quick access code among the
file properties on the Archives page of the system management web site, as
shown below.
Figure 4-3 Viewing a file's quick access code
Quick play using the H.323 menu
Use the remote control to select "Play by quick code" on the "Video Playback"
menu, and confirm. This will open the quick access code play interface, as
shown below.
To Next Page
Loading...
Need help?
General
