Polycom SoundStation IP 7000 Integration Guide

Integration Guide for the Polycom SoundStation IP 7000 Phone Connected to a Polycom HDX System in Unsupported VoIP Environments
4
5. Connect the phone to the Polycom HDX system. Refer to Connecting the
Phone to the Polycom HDX System on page 5.
6. Make any optional changes to the phone and connect the phone to any
optional components. Refer to Setting Up the Phone on page 7.
Connecting the Phone to the Network
The following figure shows how to connect the phone to the network.
To connect the SoundPoint IP 7000 phone to the network:
1. Connect the 25-foot Network Cable to the LAN jack on the phone.
2. Connect the other end of the 25-foot Network Cable to an available
LAN port on the wall or hub/switch device port.
Note
Connecting the SoundPoint IP 7000 conference phone to the network is optional,
but highly recommended (for the reasons discussed at the beginning of this
chapter).
25-foot Network Cable
1 2
Note
AC power adapters are not included in the basic phone package. Power will be
provided to the phone from the Polycom HDX system when connected using the
Polycom HDX Microphone Cable.

Polycom SoundStation IP 7000 Specifications

General

Frequency range	160 - 22000 Hz
Telephone dynamic range	85 dB
Ethernet LAN (RJ-45) ports	1
Operating temperature (T-T)	0 - 40 °C
Harmonized System (HS) code	85258900

Weight and Dimensions

Weight	1080 g
Dimensions (WxDxH)	394 x 372 x 73 mm