The SoundStructure VoIP Interface
12 - 5
SoundStructure Firmware version 1.5
This firmware version is fully compatible with configuration files created with
earlier versions of SoundStructure Studio.
SoundStructure Studio version 1.7
This studio version is fully compatible with configuration files created with
earlier versions of SoundStructure Studio. Once a configuration file has been
created with version 1.7.0 it may not be backwardly-compatible with earlier
versions.
SoundStructure VoIP Interface Firmware version 4.0.1
Support for the SoundStructure VoIP Interface requires version 4.0.1 or later of
the Polycom UC Software for the SoundStructure VoIP Interface. By default,
the SoundStructure VoIP Interface product ships with version 4.0.1 or later
installed.
Upgrading a Project to the SoundStructure VoIP Interface
An existing SoundStructure project with PSTN interface may be upgraded to
the SoundStructure VoIP Interface with the Upgrade Plug-in Card tool. This
new tool has been designed to upgrade a SoundStructure project from one set
of telephony plug-in cards to a different set of plug-in cards. This section
shows you how to use the Upgrade Plug-in Card Tool with an example that
upgrades a SoundStructure project from a SoundStructure TEL1 card to the
SoundStructure VoIP Interface.
For a summary of the all the steps required to update an install from a Sound-
Structure TEL1 to a SoundStructure VoIP Interface, see the Quick Upgrade
Guide at the end of this chapter.
Upgrading an Existing TEL1/TEL2 Project to the SoundStructure VoIP Interface
Polycom recommends upgrading telephony cards in a SoundStructure system
by working offline with the project file and running the Upgrade Plugin Card
Tool with the offline project.
Starting with an Online System
While SoundStructure Studio supports upgrading an online system, Polycom
recommends that you get the configuration file from your system and then
disconnect from the system and continue to work offline to reduce the number
of steps and simplify the upgrade process.