Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12
12 - 16
The wiring page of the new project will show the SoundStructure VoIP Inter-
face installed as shown in the following figure.
At this point, you have created an offline project that includes the SoundStruc-
ture VoIP Interface. Configuration of the SoundStructure VoIP Interface
settings will be described in Configuring the SoundStructure VoIP Interface.
If you have completed your customization, you can now upload the configu-
ration file to a SoundStructure C12 system that has the SoundStructure VoIP
Interface installed and continue with configuring the SoundStructure VoIP
Interface settings once connected online.
Upgrading the Firmware in the SoundStructure System
Before loading a project with a SoundStructure VoIP Interface to a Sound-
Structure system, ensure that you are running SoundStructure device
firmware 1.5.0 or later.
If you upload a configuration that requires a SoundStructure VoIP Interface to a
SoundStructure system that does not have a SoundStructure VoIP Interface
installed, the Upgrade Plug-in Card tool will be automatically run to allow you to
modify the project to match the installed hardware.
To Next Page
Loading...
Need help?
General
