Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12
B - 4
Adding Connected Systems to the Address Book
Once SoundStructure Studio is connected to a system, the system may be
added to the address book by right clicking on the system name as shown in
the following figure.
The system and IP address will be stored into to the address book and raise the
address book page to allow a comment to be added.
SoundStructure systems can also be added to the address book from the
‘Connect to Devices’ control by right clicking on the system name as shown in
the following figure.
Once systems are in the address book, it is possible to connect to those systems
directly by highlighting the system name and clicking the Connect button.
To Next Page
Loading...
Need help?
General
