Polytec PDV-100 - Page 60

iv
Index
S
S/P-DIF-Format 3-4
safety
general safety information
1-1
laser, safety information 1-2
safety information
electrical safety
1-5
general safety 1-1
laser safety 1-2
specific safety 1-6
safety precautions, laser safety 1-3
select
high pass filter
4-3
low pass filter 4-2
measurement range 4-2
suitable settings 4-2
selection key
at the laser vibrometer
3-3
using 5-2
serial number, of the laser vibrometer 3-5
service mode
display temperature
5-4
generate 0V test signal 5-5
generate the 2,80V test signal 5-4
in the laser vibrometer 5-4
switch the laser off 5-4
switch the laser on 5-4
settings
high pass filter
4-3
in the main menu 5-3
in the service mode 5-4
low pass filter 4-2
measurement range 4-2
on the display 5-2
select suitable 4-2
Velo 5-3
settling time 5-3
signal level display, at the laser vibrometer 5-2
signal output
ANALOG OUT, technical specifications
7-2
DIGITAL OUT, technical specifications 7-3
socket type, laser vibrometer-specifications 7-1
solar radiation 3-2
specific safety information 1-6
specification, technical
optic
7-5
specifications, technical
laser vibrometer, general data
7-1
optional accessories 7-8
power supply 7-7
specifications, technical dimensions
dimensions
7-6
stand-off distance PDV-100, technical
specifications
7-5
start-up 4-1
sticker 1-4
storage temperature, technical specifications 7-2
suitable settings
high pass filter
4-3
low pass filter 4-2
measurement range 4-2
switch on
functional test
3-7
switch on, laser in the service mode 5-4
switching on
laser in the service mode
5-4
PDV in battery operation 5-1
PDV with power supply 5-1
T
table, visibility maxima 7-5
technical specifications
charger
7-9
dimensions 7-6
operating temperature 7-2
optic 7-5
optional accessories 7-8
PDV 100, general data 7-1
PDV-100, metrological properties 7-2
power supply 7-7
supply voltage 7-1
temperature, display in the service mode 5-4
test signal 0V, generate in the service mode 5-5
test signal 2,80V, generate in the service
mode
5-4
test, functional test 3-8
testing, at the functional test 3-8
top view, control elements 3-3
tripod VIB-A-T01, assembly 3-6
U
unpacking the components 3-1
use, intended 1-1
V
Velo, settings in the main menu 5-3
view
from above
3-3
from rear 3-4
from the bottom 3-5
visibility maxima
optimal stand-off distance
4-4
PDV-100, technical specifications 7-5
table 7-5