PORTABLE ELECTRIC VOLTstack 5k - USB 5 V Charging; Self Consumption; Controller Settings; DC Operating Fuse Replacement

Controller Settings
Your VOLTstack’s operating settings are factory set. The Controller manages these settings and provides troubleshooting
information for your VOLTstack Service Technician. Only a qualified VOLTstack technician should modify operating settings.
DC Operating Fuse Replacement
A 5mm x 20mm 2A DC glass cartridge-type operating fuse is located inline with the 5V USB charger. If the fuse needs to be
replaced, use the same rating for the replacement fuse to ensure safe operation of your VOLTstack.
Hot and Cold Temperature Operation
It is important to operate your VOLTstack within the temperature ranges specified below. For optimal performance, 15-25
o
C
ambient temperature environment is recommended. Operating outside the ranges specified below can cause permanent
damage to your unit.
IDLE POWER CONSUMPTION
Mode Rate of Self-Consumption
O 5% per month
Standby 5% per day
Power ON 40% per day
OPERATING TEMPERATURE SPECIFICATIONS
Operation Ambient Temperature
AC Charging, Solar Charging 0
o
C – 50
o
C 32
o
F – 122
o
F
AC Output -20
o
C – 50
o
C -4
o
F – 122
o
F
IMPORTANT
Do NOT modify Controller settings.
USB 5V Charging
From Standby or Power ON mode, plug your USB device into one of the USB 5V charging ports located on the Face Plate.
Self Consumption
Even when not in use, The VOLTstack’s State of Charge will still decrease over time. The rate of decrease depends on the
Power Mode of the unit. The Table below lists each Power Mode and the corresponding rate of decrease of State of Charge.
Version 1.0 September 2019
24