G2000/G3000/G6000 Industrial User’s Manual Chapter 2: Setup and Use
8
Connecting the Printer
Power Connection
Warnings:
(1) Do not use the printer near liquids or corrosive chemicals.
(2) Using the wrong power adapter may cause damage to your printer. Postek assumes no liability for any damage in
such cases. The power rating for the printer is 24VDC.
1. Make sure the printer is switched OFF.
2. Connect the power cord to the Power Adapter.
3. Connect the Power Adapter’s DC output plug to the DC IN port on the back of the printer.
4. Plug the power cord into a live wall outlet.
Interface Connection
The G Series Industrial supports RS-232 Serial, USB 2.0, Ethernet and Centronics Parallel (optional) interface
connections.
Note: When connecting the G Series Industrial printer to a computer via the USB interface cable, make sure to utilize
the same USB port used during the driver installation process, which enables the printer to retrieve needed commands or
data from the PC. If the same USB port is not available or not known, then in the printer’s Properties Dialogue Box,
under the Ports tab, ensure the current port location is checked.
To connect:
1. Make sure the printer is powered OFF.
2. The printer will identify the communication port automatically.
Notes:
a. The default values of printer port can be obtained from the self-test report. (See Chapter 2: Operation Basics/
Advanced Functions/ Self Test)
b. Cable configurations for Serial (RS-232C) interface and parallel (Centronics) is found in Appendix A of this
guide.
c. Please take the following measures to reduce cable noise.
- Restrict the length of the interface cable to less than 6′ (1.83 M) if possible.
- Keep the interface cable separate from power cords.
To Next Page
Loading...