G2000/G3000/G6000 Industrial User’s Manual Chapter 2: Setup and Use
22
Adjusting the Position of Media Sensor
Note: Media sensor adjustment only applies to the reflective sensor.
1. Lift the top cover.
2. Push the Printhead Release Lever to release the Printhead Module.
3. Lift the Printhead Module to expose the Media Sensor cover (see Figure 7-1).
4. Remove the Media Sensor cover and slide the Media Sensor to the appropriate position (see Figure 7-3, 7-4 and 7-5).
5. Replace the media sensor cover.
Note: If there is more than 1 column of media, the Media Sensor must be positioned under the labels of any of the columns.
The Media Sensor CAN NOT be positioned right under a vertical gap or over the outer edge of the media, or an error will
occur.
Figure 7-1
Reflective media sensor cover
To Next Page
Loading...
