G2000/G3000/G6000 Industrial User’s Manual Chapter 2: Setup and Use
15
Loading the Media
The G6000 Industrial printer can be operated in four different modes: Standard, Cutting, Tear Off and Manual Peeling
modes.
– In Standard mode, each printed label remains on the backing liner.
– In Cutting mode, the printer automatically cuts the label after it is printed. Requires optional cutter kit. Simply set
this function in the LCD menu.
– In Tear Off mode, the labels will be fed to the tear bar. Simply set this function in the LCD menu.
– In Manual Peeling mode, the printer pauses after each label is printed. Simply set this function in the LCD menu.
Standard Mode
To load media into the G6000 Industrial printer while using Standard Mode:
1. Lift up the top cover to expose the media compartment (see Figure 6-1).
2. Load a roll of media (labels facing up) on the Media Spindle, then slide the two Media Roll Guides, with smooth
sides facing toward the media, onto the Media Spindle from each end until snug against the media. When placing a
roll of media with a 3″ ID core, please slide the two Core Adapters onto the Media Spindle first (see Figure 6-2).
3. Insert the entire unit into the media compartment in the printer.
4. Position the media roll in the middle of the Spindle, using the scale for guidance.
5. Release and lift the Printhead Module.
6. Route the media as shown in Figure 6-3.
7. Slide the Media Guide to the edge of the media.
8. Close the Printhead Module and press down until it locks into place (see Figure 6-4).
9. Close the cover and press the “Feed” button to feed the media and ensure proper tracking. If the printer does not
correctly detect each label, it may be necessary to perform the Media Calibration procedure (found in the Operation
Basics section.)
To Next Page
Loading...
