Q8 Series User’s Manual
ii
Important Safety Instructions
♦ Only qualified and trained authorized POSTEK service providers should attempt to disassemble or repair the printer.
Incorrect disassembling of the product or its power adaptor may cause an electronic short, human injury or printer
component damages.
♦ Do not use a worn or damaged power cord as it could result in electric shock and personal injury. If the power cord
becomes damaged or frayed, replace it immediately.
♦ Be sure that the output of the power adapter is 24VDC and your power source matches the rating listed on the power
adapter. Ensure the power source is grounded.
♦ Do not insert anything into the ventilation slots or openings on the printer.
♦ The printer and power adapter should never be operated in a location where either one can get wet. Personal injury may
result.
♦ The Printhead becomes hot while printing. To protect from damaging the Printhead and risk of personal injury, avoid
touching it.
♦ To obtain increased Printhead longevity and higher quality output, always use quality labels, tags and thermal transfer
ribbons. Check for quality supplies with a POSTEK reseller.
♦ Static electricity that accumulates on the surface of the human body or other surfaces can damage or destroy the
Printhead or electronic components in this device. DO NOT touch the Printhead or the electronic components with bare
hands.
♦ Place the printer on a flat, firm, solid surface.
Warnings:
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be
required to take adequate measures (see FCC Notice).
Static electricity that accumulates on the surface of the human body or other objects can damage the print head or electronic
components in the V6 printer. Observe proper electrostatic safety precautions when handling.
♦ Power off the printer when not in use for extended periods of time.
♦ Never operate in a high temperature environment.
♦ Follow all recommendations and setup instructions included in this manual.
To Next Page
Loading...
