Postek Q8 - Driver and Software Installation

Chapter 3: Operations and Settings Q8 Series User’s Manual
27
DIP Bit
Functions
Remarks
1
ON: Direct thermal print
OFF: Thermal transfer print
Printing type setting
Default: OFF
2
ON: Tear off position
OFF: Edge of next label
Stop position setting
Default: OFF
3
ON: Cutter is installed
OFF: Cutter is not installed
Cutter setting
Default: OFF
4
ON: Peeler is installed
OFF: Peeler is not installed
Peeler settings
Default: OFF
5 Reserved and not available
6
ON: Enable IP setting
OFF: Disable IP setting
IP address setup
Default: OFF
7
8 7
0 | 0 – 9600,n,8,1
0 | 1 – 19200,n,8,1
1 | 0 – 38400,n,8,1
1 | 1 – 57600,n,8,1
RS232 Serial Port baud rate setting
0: OFF, 1: ON
Default: 00
8
Windows Driver and PosLabel Software
The Q8 printer is compatible with the following operating systems:
•
Windows 7
•
Windows Me
• Windows Vista • Windows 2000
• Windows XP
• Windows 2003
• Windows 9X
Additionally, the Q8 printer comes with powerful bar code software, PosLabel.
Both the Windows driver and PosLabel are available on the CD-ROM shipped with the product. Software upgrades are
available for download from:
www.postek.com.cn (Choose English version) or,
www.postektechnologies.com
Note: Prior to uploading a new driver or installing an updated driver, remove any old version of the driver that may be
stored in your computer.