- 20 -
Adjusting the measurement conclusion
• Press the button RANGE
e
once to switch from the automatic to the
manual measurement conclusion.
The indicator AUTO extinguishes.
• Press the button
RANGE
e
once again to show the various measurement
conclusions, one after the other. Subject to the fed voltage, the display
of the measurement conclusions begins with one of the following indicator
formats:
-> Measured value in Millivolt (mV) with one decimal place
-> Measured value in Volt (V) with three decimal places
-> Measured value in Volt (V) with two decimal places
-> Measured value in Volt (V) with one decimal place
-> Measured value in Volt (V) without decimal places
After this, the display of measurement conclusions starts again from the
beginning.
• To switch back to automatic measurement conclusions, hold the button
RANGE
e
pressed down for approx. 2 seconds.
Note:
If the indicator OL appears in the display
z
, the measured value is located
outside of the measurement conclusion. In this case, enter in a higher measure-
ment conclusion. With open measurement prods and an automatic measure-
ment conclusion, a vacillating measurement conclusion appears in the mV
range, resulting from the high input sensitivity. During the actual measure-
ment a stable and correct indication is given.
To Next Page
Loading...