- 19 -
Voltage measurement
Warning!
NO MORE than 600 V
~
resp. 600 V may be fed in at the input sockets.
Should this limit be exceeded, there is a risk of both damaging the device
and an imperilment of the user.
Caution
Disconnect the measurement prods from the object being tested before
selecting a different area of measurement. Otherwise, the device could
be damaged.
• Place the function switch
q
at the position .
The indicator for direct voltage measurement appears.
Press the button
FUNC.
r
to switch between
either direct current or alternating current measurement .
• Insert the measuring leads into the input sok-
kets
VΩ
7
and COM
8
.
• Connect the measurement prods with the object being tested.
The measured value is shown in the display
z
, depending on the voltage
size and the measurement conclusion, in Millivolt (mV) or Volt (V).
To Next Page
Loading...