- 30 -
Adjusting the measurement conclusion
• Press the button RANGE
e
once to switch from the automatic to the
manual measurement conclusion.
The indicator AUTO extinguishes.
• In the position press the button
RANGE
e
once again to show
the various measurement conclusions, one after the other:
- Measured value in milliampere (mA) with two decimal places.
- Measured value in Milliampere (mA) with one decimal place.
• To switch back to automatic measurement conclusions, hold the button
RANGE
e
pressed down for approx. 2 seconds.
Note:
If the indicator OL appears in the display
z
, the measured value is located
outside of the measurement conclusion. In this case, enter in a higher measure-
ment conclusion. With open measurement prods and automatic measurement
conclusion the indicator OL also appears.
To Next Page
Loading...