To navigate between hyperlink topics using a keyboard, select ALT+◄ or ALT+►.
14
Table of Contents
To connect directly to the battery:
a. Remove the battery access door and screw.
b. Unplug the quick connect cable from the wiring harness.
c. Remove the battery hold down strap, then remove the battery.
d. Connect the positive and negative alligator clips of your charging cables to the corresponding battery terminals.
2. Charge the battery for 3 hours or until fully charged.
3. When the battery is fully charged:
• After back-charging, disconnect the battery charger from the DC receptacle.
• After charging the battery directly, reinstall the 12V battery and the battery access door and screw.
Because a lead acid battery may become depleted when it's not in use, remember to recharge the 12V battery
after long-term storage.
Replacing the 12V Battery
To Next Page
Loading...
