powersoft K2 - Specifications: K10 and K10 DSP+AESOP

49
K2 K3 | SERVICE MANUAL
INDEX
Launch the update and wait until the rmware has been
completely uploaded into the smart card. (Fig. 71)
(Fig. 71)
(Fig. 72)
If you want verify the rmware loaded into the smart card,
consider that the process takes more than one hour. (Fig. 72)
If you forget to press the rst right-hand MENU button
on your amplier BEFORE inserting the smart card,
the Powersoft Firmware Updater Software displays the
warning message portrayed on (Fig. 73)
(Fig. 73)
Remember to mark the smart card according to the firmware version.
Select the device hosting the smart card. Please
be patient if the connected ampliers are not listed
immediatly: the recognition process can be quite slow
even with an Ethernet connection. (Fig. 70)
(Fig. 70)