Need help?Do you have a question about the powersoft K2 and is the answer not in the manual?
General| Frequency Response | 20 Hz - 20 kHz (±0.5 dB) |
|---|---|
| THD+N | < 0.1% |
| THD | < 0.05% |
| S/N Ratio | > 100 dB |
| Damping Factor | >500 @ 100Hz |
| Input Impedance | 20 kOhms balanced |
| Dimensions | 483 x 44.5 x 358 mm (19 x 1.75 x 14.1 in) |
| Weight | 7 kg (15.4 lbs) |
| Input Sensitivity | 1.4V |
Explains the meaning of various safety symbols used in the manual.
Details compliance with FCC rules and operational conditions.
Lists directives and standards Powersoft products comply with.
Congratulates user, advises reading manual and safety instructions.
Instructions for inspecting the product upon delivery for any damage.
Highlights advanced features, digital control, and PFC technology.
Explains efficiency, reduced heat, and smaller size of Class D amplifiers.
Identifies connectors and controls on the rear panel of K2/K3 models.
Identifies connectors and controls on the rear panel of K6/K8/K10/K20 models.
Specifies requirements for proper airflow and heat dissipation.
Details how to connect the amplifier to the AC mains supply safely.
Advises on proper signal grounding to minimize interference.
Describes the analog input connectors and signal polarity.
Explains the AES3 digital input functionality and switching.
Describes how to connect speakers using Neutrik speakON connectors.
Describes how to connect the amplifier for remote control via RS-485.
Explains the meaning of different LED indicator states on the front panel.
Guides the user on how to access and navigate the amplifier's main menu.
How to set the amplifier's output attenuation level.
How to match input sensitivity with other equipment.
How to choose between Analog, AES3, or KAESOP input sources.
How to set the maximum current the amplifier draws from the mains.
How to configure clip limiters to prevent output distortion.
How to activate power saving by turning off the output stage.
Choosing the input signal source for DSP processing.
Configuration options for AES3 input streams, including gain and backup.
Interface for configuring 16 parametric filters for output equalization.
Configuration of crossover filters (low-pass, high-pass, band-pass).
Explains limiters for protecting speakers from damage.
Details the peak limiter for preventing cone displacement.
Details power limiters for preventing thermal damage to voice coils.
Mutes outputs during power on/off to protect speakers.
Protects the amplifier output stage from short circuits.
Monitors temperature and adjusts fan speed or mutes channels.
How to update the amplifier's internal firmware using a SmartCard.
Using a SmartCard to upgrade amplifier performance or model.
Introduction to Powersoft's software for system configuration and control.
Describes integration with Q-Sys, Crestron, AMX, and MediaMatrix.
Details the terms and conditions of the product warranty.
Information on obtaining technical support and service.
To Next Page
