Powerware 5125 - Operation; Turning the UPS On and Off; Starting the UPS on Battery

29
Powerware
®
5125 Two-in-One (2400–3000 VA) User’s Guide : www.powerware.com
CHAPTER 4
OPERATION
This section describes:
:
Turning the UPS on and off
:
Starting the UPS on battery
:
Initiating the self-test
:
Operating modes
Turning the UPS On
After the UPS is connected to a power outlet, it conducts a self-test and
enters Standby mode. To turn on the UPS, press and hold the
On
button until you hear the UPS beep (approximately one second).
The

indicator stops flashing and the load level indicators display the
percentage of load being applied to the UPS.
Starting the UPS on Battery
NOTE Before using this feature, the UPS must have been powered by utility power at
least once.
To turn on the UPS without using utility power, press and hold the
On
button for at least four seconds. The UPS supplies power to your
equipment and goes into Battery mode. When the UPS starts on battery,
it does not conduct a self-test to conserve battery power.
Turning the UPS Off
To turn off the UPS, press and hold the Off button until the long
beep ceases (approximately five seconds). The

indicator begins to
flash and the UPS remains in Standby mode until you unplug the UPS
from the power outlet.