Powerware 5125 - Bypass Mode; Standby Mode

Operation
32
Powerware
®
5125 Two-in-One (2400–3000 VA) User’s Guide : www.powerware.com
Bypass Mode
In the event of a UPS overload or internal failure, the UPS transfers your
equipment to utility power. Battery mode is not available; however, the
utility power continues to be passively filtered by the UPS. The alarm
sounds and the
 indicator illuminates red. The UPS switches to
Bypass mode when:
:
The UPS has an overtemperature condition.
:
The UPS has an overload condition of 103 to 110% for 30 seconds.
:
The UPS detects a fault in the battery or UPS electronics.
Standby Mode
When the UPS is turned off and remains plugged into a power outlet,
the UPS is in Standby mode. The

indicator flashes and the load level
indicators are off, indicating that power is not available from the UPS
output receptacles. The battery recharges when necessary.