C556, C556i Navy Self Powered Elliptical Fitness
Page 51
10. Slide the large plastic spacer onto the stairarm peg. Slide the spacer into the bushing in the
handlebar linkage and place a washer on each side of the spacer. Set the handlebar linkage
at its mounting position and fasten it with the bolt removed in step 3. Torque the handlebar
linkage bolt to 200 inch pounds. Snap the plastic cap removed in step 3 into the handlebar
linkage.
11. Set the stairarm pedal at its mounting position, install and hand tighten the stairarm pedal
mounting hardware removed in step 6. Torque the stairarm pedal mounting bolts to 60 inch
pounds.
To Next Page
Loading...
Need help?
General
