C556, C556i Navy Self Powered Elliptical Fitness
Page 9
Procedure 3.3 - Displaying the Odometer
Procedure
1. Start pedalling and continue to pedal as you perform step 2.
2. With the PRECOR banner scrolling, press keys RESET,6,5, sequentially.
3. The message INFORMATION DISPLAY will be displayed for a few seconds.
4. The message ODOMETER will be displayed followed by the total number of strides
accumulated. The total number of strides can be converted to miles by dividing by 2241 or
to kilometers by dividing by 1392.5. Press the ENTER key to advance to total strides.
5. The message TOTAL STRIDES will be displayed followed by the total number of strides
logged on the C556. Press the ENTER key to advance to hour meter.
6. The message HOUR METER will be displayed followed by the total number of hours that
the EFX has been in use. Press the ENTER key to advance to software version.
7. The message SOFTWARE VERSION will be displayed followed by the software versions of
the upper and lower PCA’s. For example, UPPER 1.01 LOWER 1.01. Press the ENTER key
to advance to error log.
The message ERROR LOG will be displayed followed by the error in log position 1. Each log
entry shows the log position, the stride count when the error occurred and the hour meter when
the error occurred. For example; 1 ER21 123456 STR 45678 HRS. The error log can record up
to ten error conditions. The error code in position one will be the most recent error and the error
in position ten will be the oldest error. If more than ten errors have been logged, only the ten most
recent will be displayed. When a new error is logged, each the
and keys to move through
the log. Pressing and holding the QUICK START key for four seconds will clear the log. Press
the ENTER key to exit the odometer program.
To Next Page
Loading...
Need help?
General
