C556, C556i Navy Self Powered Elliptical Fitness
Page 53
6. Remove the ramp from the EFX.
7. Slide the ramp end cap into the ramp assembly. Fasten the ramp end cap with the screws
removed in step 3.
8. Set the ramp assembly at it’s mounting position. Hand start the rear mounting bolts and the
two front bottom mounting bolts. Torque the rear mounting bolts to 120 inch pounds. Torque
the two front bottom mounting bolts to 100 inch pounds.
9. Rotate both stairarms forward onto the ramp assembly.
10. Set the pivot arm connectors at their mounting positions on the stairarms. Replace and
torque the six pivot arm connector bolts to 135 inch pounds.
To Next Page
Loading...
