page 33
Keys on the Keypad
The following information explains the different uses of the keys from left to right. To
locate each key, look at the display console or refer to Diagram 26.
CROSSRAMP
▲▼▲▼
▲▼▲▼
▲▼: During a workout, the Crossramp
▲▼▲▼
▲▼▲▼
▲▼ keys let you increase or
decease the ramp’s incline . The display can show a range from 1 to 17. Setting 1
provides the lowest incline.
When you change the incline by pressing the Crossramp
▲ ▲
▲ ▲
▲ or
▼▼
▼▼
▼ key, the number
that appears on the display shows the
target
incline (not necessarily, the present
incline) because the display can change much faster than the ramp level.
Note: Any time during your workout, you can view the actual incline by lightly
touching either Crossramp
▲ ▲
▲ ▲
▲ or
▼▼
▼▼
▼ key. You can opt to change the incline, if you
hold the key down for more than one second.
During Setup mode, the Crossramp
▲▼▲▼
▲▼▲▼
▲▼ keys are used for data selection. Pressing
either
▲ ▲
▲ ▲
▲ or
▼▼
▼▼
▼ key does not affect the ramp's incline. However the
▲ ▲
▲ ▲
▲ or
▼▼
▼▼
▼ keys do
affect what appears on the display. Refer to
Setup Mode and Prompts
on page 30.
SELECT keys 1 and 2: While the Precor banner is displayed, the SELECT keys act
as User I.D. 1 and 2 (respectively). During a course, the Select keys change what
items appear on the display. Refer to page 34,
Changing the Display Features Using
the SELECT Key
.
User I.D. keys 1 and 2 — While setting up for your workout, the SELECT keys act as
User I.D. 1 and 2 (respectively). Choosing a User I.D. enables the EFX to identify you
and remember your last course, workout time, weight, and age. If another person
works out on the EFX, he or she can select a User I.D. of their own and personalize
their workout session. To learn more about this feature, refer to
User I.D.
on page 33.
To learn about choosing the display items and setting up an automatic scan of the
workout data, refer to
Changing the Display Features Using the SELECT Key.
RESET: Provides access to diagnostics (see
Advanced Techniques
on page 35),
and lets you exit a course or the Setup mode prematurely. If you press Reset while
in a course, you exit the course and access the Workout Summary display. Press
Reset again to exit Workout Summary and return to the Precor banner or wait for
the ten minute time-out. Note that if you press Reset during the Setup mode, you
also return to the Precor banner.
Diagram 26
EFX
®
5.23 keypad.
Keypad keys
The keys on the keypad let you:
• control your workout session,
• answer prompts prior to starting a course,
• determine which display features appear,
• prematurely end a course, and
• adjust the resistance and incline levels.
To Next Page
Loading...
Need help?
Power
Incline and Programs
Weight and Dimensions
