Daily Task Instruction
water.
Clean the running belt top surface. Clean the top surface of the running belt with a soft
dry or damp cloth using an approved cleaner.
Clean the running belt and deck. Clean the running belt and deck, see "Running Belt
and Deck Cleaning Procedure" on page99,
Check for the following possible
issues:
l Slipping belts
l Loose fasteners
l Unusual noises
l Worn or frayed power cords
l Worn, damaged, missing
safety lanyards or clips
Verify that none of the following issues are occurring:
l Slipping belts
l Loose fasteners
l Unusual noises
l Worn or frayed power cords
l Worn, damaged, missing safety lanyards or
clips
Visually inspect the running belt con-
dition and alignment/tracking.
Make sure that the running belt is not frayed/worn
and that the belt alignment and tracking is centered
on the deck and rollers.
Weekly
Perform the following maintenance tasks every week:
Weekly Task Instruction
Verify unit sits level and solid on floor. Use bubble level placed on running belt to verify
level. All feet should be touching the floor and
the unit should not rock or wobble when in use.
Perform the following items at maximum
Incline, power switch OFF, and cord dis-
connected:
Raise Incline to maximum level, then Switch the
input power (circuit breaker) to OFF and unplug
the power cord.
l Verify that the power cord is not
damaged or laying underneath the
treadmill
1
.
Verify that the power cord is not damaged,
pinched, coiled, or positioned under the tread-
mill.
l Vacuum and clean area under-
neath equipment
1
.
Vacuum and/or use damp mop to clean floor
area underneath equipment. Make sure the floor
is completely dry.
l Clean surfaces on foot contact loc-
ations
1
.
Use a soft nylon scrub brush to clean the
grooves and textured surfaces on foot contact
locations.
Connect power cord and Switch the input
power ON, set incline to 0%.
Plug-in the power cord and switch unit power
ON. The incline level will automatically reset to
the 0% "Home" position.
Verify the treadmill operation and func-
tionality.
Perform the "Operation Verification Procedure"
on page8 to verify unit features and functions
(Undefined variable: TRM700-16Base.ServiceManualTitle)
97
7 Preventative Maintenance
Maintenance Schedule
To Next Page
Loading...
