l Touchscreen Calibration: Follow screen prompts to complete test. When
the test is completed the console will automatically exit and return to the
System Tests menu.
l Touchscreen Test: Verify that there is a trace created that follows your fin-
ger movement across the touchscreen surface. Select Finish to exit. move
your finger and verify that a trace follows
l Backlight Test: Tests the display backlight brightness. Follow prompts to
complete test.
l RGB Test: Touch the screen to cycle through the test colors: Red, Green,
Blue, White, & Black. Returns to the System Tests menu when completed.
l Numeric Backlight Test: Tests the controls numeric display brightness.
Returns to the System Tests menu when completed.
l Numeric Display Test: Tests the controls numeric display. Returns to the
System Tests menu.
2. Exit the Diagnostic Test menu. (press Back to exit & return to the banner screen)
Motion Controls Test
Verify the machine operation.
1. Select QUICKSTART to begin a manual workout and operate the treadmill at
least 5 minutes. While walking on the unit perform the following tests:
2. Operate the SPEED motion control from minimum to maximum range while veri-
fying the machine operation.
l Make sure that the console SPEED paddle control operation is smooth
and working correctly.
l Verify that the running belt can reach the maximum speed and then returns
to the minimum speed level.
l Make sure that the running belt speed change is smooth and that there are
no unusual noises.
l Verify that the console SPEED indicators and workout displays are show-
ing correct information.
3. Operate the INCLINE motion controls from minimum to maximum range while
verifying the machine operation.
l Make sure that the console INCLINE paddle controls operation is smooth
and working correctly.
l Verify that the running deck can reach the maximum incline and then return
to the minimum incline level.
l Verify that the lift motor operation is smooth while changing the INCLINE
from minimum to maximum levels.
l Verify that the console INCLINE level indicators and user workout displays
are showing correct information.
Running Belt Test
Verify the running belt alignment and tracking.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 10
3 Operation Verification
Operation Verification Tests