S3.19 Assembly and Maintenance Guide
page 35
Cable Adjustments and Maintenance, continued
4. Maintenance
Guide Rods
A Apply one tube of lubricant to each Guide Rod.
B. Lubricate the Guide Rods every six months.
CAUTION: The lubricant can stain clothes. Wear
proper attire when lubricating the Guide Rods.
Inspection
Inspect the unit daily.
Look and listen for frayed or worn parts, loose
fasteners, cable tension issues, unusual noises, and
any other indications that the equipment may be in
need of service.
You are responsible for the proper maintenance of the
unit as discussed in this manual. For other service
issues, contact Customer Support. Refer to Obtaining
Service.
1
3
2
4
5
6
7
8
9
10
11
12
13
14
15
Lubricant Guide Rod
A
Shrouds
CAUTION: Clean the Shrouds with product
specifically labeled as safe for acrylic. Use a clean,
nonabrasive cloth and light pressure to avoid
scratching the acrylic surface.
The acrylic Shrouds on the S3.19 are easily scratched
or damaged through improper cleaning techniques. To
avoid problems, dust the shrouds often with a clean,
lint-free cloth and light pressure. Avoid rubbing dirt or
grit into the surface. If you use glass cleaner or a similar
product, make sure the label states that it is safe to use
on Plexiglas® or acrylic products.
Important: DO NOT use ketones, aromatics, esters,
halogens, window cleaning sprays, alcohol, kitchen
scouring compounds, or solvents (such as acetone,
benzene, gasoline, carbon tetrachloride, or thinners). Do
not use ammonia-based cleaning solutions because
the ammonia destroys the plastic coating.
To remove light scratches on the smooth side only, use
a buffing compound such as, car wax. Lightly buff the
acrylic sheet using a clean buffer until the scratches
disappear.
To Next Page
Loading...
Need help?
Weight and Dimensions
