© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 96
Vacuum and clean area underneath
equipment
1
.
Vacuum and/or use damp mop to clean floor area
underneath equipment. Make sure the floor is
completely dry.
Clean surfaces on foot contact locations
1
.
Use a soft nylon scrub brush to clean the grooves and
textured surfaces on foot contact locations.
Connect power cord and switch the input power ON, set incline to 0%.
Verify the treadmill operation and
functionality.
Perform the “Operation Verification” procedure to
verify unit features and functions (parameter controls,
HHR, Stop key. etc.).
Note: 1). Perform test with incline set to maximum level and power OFF and power cord
disconnected.
Monthly
Perform the following maintenance tasks every month.
Verify the Safety clip is attached to the
lanyard and functional.
Pull on the lanyard attached to the Safety clip which
trips the Restart (Stop/Restart) switch. The "PUSH
TO RESET SWITCH" message is shown and an
arrow pointing to the Restart switch. Treadmill slows
and stops.
Inspect the power cord for damage and
that the cord clamp is securely installed
1
.
Inspect the power cord, make sure it is not damaged
or underneath the treadmill. Verify the cord clamp is
securely installed.
Visually inspect the running belt and deck
condition.
Make sure the deck and belt are not worn and are in
good condition, replace as necessary.
Verify the running belt alignment and
tracking.
Verify the running belt alignment and tracking, see
"Running Belt Tension and Tracking Adjustment"
procedure.
Clean the treadmill’s frame using a cloth
dampened with an approved cleaning
solution
1
.
Use only approved plastic cleaners.
To Next Page
Loading...
Need help?
General