95
9 Master Control
9.6 Scenes and Projects
StudioLive™ Series III
Owner’s Manual
9.6.5 Scene Safe
In some cases, you may want to protect a channel or bus from being affected when
scenes are recalled. To do this, touch the Scene Safe button. This opens the Scene
Safe screen on the Touch Display.
This screen shows you a list of all available channels and buses. Touch the channel or
bus of your choice to put it into scene safe mode, and protect it from changes when
scenes are recalled.
When a channel is included in the Scene Safe group, a padlock will appear on its
scribble strip to alert you that it will be omitted from any Scene that is recalled.
9.6.6 AutoStore
It is not necessary to create a scene for your StudioLive in order to preserve its
settings when you power it down. The StudioLive takes continuous snapshots of the
current position of every parameter on the mixer and stores them to memory every
3 seconds. This ensures that the next time you turn your StudioLive on, all of your
settings will be restored to the same setting they were in when you powered down.
The AutoStore to Disk icon will flash in the upper left-hand corner of the Touch
Display when an AutoStore snapshot is taken, alerting you that it is safe to power
down your mixer.
Note: If you make changes to a stored scene, AutoStore will not save these changes as a
permanent part of the scene. Any changes made to a scene in the StudioLive’s library
must be saved using the Scene menu, as described in the first part of this section.
Inputs
User
Main
Mix
NextPrev
Solo
Mute
Select
Solo
Mute
Select
Solo
Mute
Select
Solo
Mute
Select
Solo
Mute
Select
Solo
Mute
Select
Select
1 17 18
19 20
21 22
3
5
2
4
6
23 247 8
Ch 1
1
Ch 2
2
Ch 4
3
Ch 4
4
Ch 5
5
Ch 6
6
Ch 1
1
To Next Page
Loading...
