66
6 The Fat Channel
6.8 Fat Channel Screens
StudioLive™ Series III
Owner’s Manual
5. Band 1 Select. Selects Band 1 for control via Gain (#1), Frequency (#2),
and Q (#3).
6. Band 1 On/Off. Enables/disables Band 1.
7. Band 2 Select. Selects Band 2 for control via Gain (#1), Frequency (#2),
and Q (#3).
8. Band 2 On/Off. Enables/disables Band 2.
9. Band 3 Select. Selects Band 3 for control via Gain (#1), Frequency (#2),
and Q (#3).
10. Band 3 On/Off. Enables/disables Band 3.
11. Band 4 Select. Selects Band 4 for control via Gain (#1), Frequency (#2),
and Q (#3).
12. Band 4 On/Off. Enables/disables Band 4.
Note: When one of the output buses is selected, Bands 5 and 6 will also
be visible.
13. Output Meter. Displays the post-EQ Output signal.
14. High Shelf On/Off. Enables/disables the high shelf EQ. When the Shelf button is
not engaged, the High band is a parametric EQ. Enabling the Shelf button turns
the High band into a high shelving EQ that alters, by a fixed amount, a band of
high frequencies at and above a user-selected shelving frequency.
Power User Tip: A high shelving EQ is like a treble-control knob on a stereo. In this
mode, the Center Frequency control selects the shelving frequency.
15. Low Shelf On/Off. Enables/disables the low shelf EQ. When the Shelf button is
not engaged, the Low band is parametric. Enabling the Shelf button turns the
Low band into a low-shelving EQ that alters, by a fixed amount, a band of low
frequencies at and below a user-selected shelving frequency.
Power User Tip: A low shelving EQ is like a bass-control knob on a stereo. In this
mode, the Center Frequency control selects the shelving frequency.
16. Pre/Post. Switches the RTA measurement between Pre- or Post-EQ.
17. RTA. Engages/disengages the RTA display in the EQ graph.
18. Graph. Displays EQ curve.
19. EQ On/Off. Globally switches all EQ bands On or Off.
6.8.5.2 Passive Program EQ Overview Screen
When the Fat Channel is in Passive EQ mode, the Touch Display shows an overview
screen, displaying the relevant parameters. Touching any onscreen knob allows you
to use the Master Control encoder to set the selected parameter.
Power User Tip: For StudioLive models with dynamic Fat Channel displays, many of these
parameters can also be controlled from the encoders and buttons in the Fat Channel. See
Section 6.6.2 for details.
To Next Page
Loading...
