Prestige APSRS - Turbo Timer; Silent Arm and Disarm

APSRS_RevC_9/19
24
Quick Reference: Programming & Diagnoscs
2 /4 Hour Timed Start
This module has the ability to start the vehicle automacally at med intervals. This feature can be useful in extremely
cold climates where starng the engine is the only means to keep the baery charged and uids warm. The factory
preset start me is four (4) hours.
To select between two (2) and four (4) hour mers:
1. Press and hold the valet buon.
2. Cycle the vehicle's Ignion ON/OFF 1x.
3. Release the valet buon.
4. Within ten (10) seconds, press and release the valet buon two (2) or four (4) mes.
The vehicle's parking lights will ash two (2) or four (4) mes to indicate the mer selecon.
To acvate two (2) and four (4) hour mer:
1. Cycle the vehicle's Ignion ON/OFF 1x.
2. Within ten (10) seconds, press and release the Start buon on the remote control four (4) mes.
The vehicle's parking lights will ash four (4) mes to indicate the mer is acvated. The vehicle will automacally start
every two (2) or four (4) hours as programmed for a maximum of forty-eight (48) hours. To cancel 2/4 hour mer mode,
start the vehicle using the remote control or the vehicle's Ignion key.
Turbo Timer
This model is equipped with a Turbo Timer. This feature will automacally engage the remote start to keep the vehicle's
engine running. This will allow for the engine to properly cool down and circulate uids though the vehicle's Turbo
Charger. The Turbo Timer duraon must be selected in Feature Bank 3 before it can be acvated by the user.
To acvate the Turbo Timer:
1. Start with the vehicle's engine running for at least een (15) seconds.
2. Apply the vehicle's Parking Brake.
3. Press and release the valet buon two (2) mes. The vehicle's parking lights will ash two (2) mes for conrmaon.
4. Release and apply the vehicle's parking brake.
To use the Turn Timer feature:
1. With the engine running, acvate the vehicle's Parking Brake.
2. Release the vehicle's brake pedal.
To cancel the Turbo Timer feature, press and release the vehicle's brake pedal or use the Start funcon on the remote
control. To prevent the Turbo Timer feature from engaging, press and hold the brake pedal while seng the vehicle's
Ignion to the OFF posion.
Silent Arm and Disarm
Program the Presge system to arm and disarm without nocaon beeps. (The siren will sound if the system is
triggered while armed.)
1. Turn the ignion ON then OFF.
2. Press and release the valet/programming buon three (3) mes. The system will respond with one (1) beep for ON or
two (2) beeps for OFF.