Prestige APSRS - Setup Options

APSRS_RevC_9/19
8
Detailed Descripons: Setup Opons
Bank 1: Add / Remove Remote Controls
To Auto Program a remote control:
1. Turn the ignion key to ON.
2. Press and release the valet/override buon three (3) mes.
3. The system will beep one (1) me, indicang you have accessed Bank 1, Remote Programming.
4. Press the Lock buon of each remote control you wish to program. (Channels 1-3 of the remote control will be
programmed.) The system will beep one (1) me when each remote control is added.
5. Turn the ignion key to OFF to exit programming mode, or cycle the ignion key OFF/ON to advance to the next
Feature Bank.
To delete a remote control:
This system will store a maximum of four (4) remote controls in the memory. Addional programmed remote controls
will delete the oldest-programmed remote control.
Deleng All Remotes:
1. Perform steps 1-3 above.
2. Press and hold the Valet/Override buon for ve (5) seconds.
3. The system will sound one (1) long beep. This indicates all remotes have been deleted from memory.
Notes:
• The system will store in the memory a maximum of four (4) remote controls. Addional programmed
remote controls will delete the oldest-programmed remote control.
• The system will accept a maximum of two (2) 2-Way remote controls.
• During normal operaon, the Programmed Transmier Nocaon (PTN) funcon indicates how many
remote controls are programmed by ashing the LED a certain number of mes when the vehicle ignion is
turned on.
AUX Output Controls.
AUX Output Controls are not congured during the Auto Programming sequence. This allows for customizaon by the
installer or user. To program AUX Output Control:
1. Repeat steps 1-3 above.
2. Press the valet buon to advance to the AUX Channel to be programmed. The system will beep to indicate the
channel number.
3. Press the desired buon or buon combinaon selected to control the AUX output. The system will beep 1x to
indicated the channel is programmed.
4. Repeat steps 2-3 unl all desired AUX outputs are programmed or turn the ignion key to OFF to exit programming.
Remote programming is located in Feature Bank 1. This system will Auto Program basic funcons of the remote with one
(1) buon press. Basic funcons are channels 1-3, Lock, Unlock, and Trunk / Start.
1 Auto Program/Lock
2 Unlock
3 Trunk/Start
4 Ch. 4 AUX
5 Ch. 5 AUX
6 Ch. 6 AUX
7 Ch. 7 AUX
Channel
Feature Bank 1
Press Lock button on remote
Press Unlock button on remote
Press Trunk/Start button on remote
Press button/buttons to control AUX Ch. 4
Press button/buttons to control AUX Ch. 5
Press button/buttons to control AUX Ch. 6
Press button/buttons to control AUX Ch. 7
Description