45
PRIMERGY TX200 S3 User’s Guide
2
Checking before OS Installation
2 Check the MAC address.
Start up the server from the network.
The MAC address is displayed as shown below.
The MAC address is required for remote installation. Write it down.
` You can turn the power on from a client (via a LAN) by utilizing the Wakeup On LAN (WOL) function.
Refer to "5.5.5 Turning the Power On via a LAN" (Jpg.157).
` Be sure to install ServerView to control the power supply via a LAN.
Unless ServerView is installed, the server is not turned off automatically after shutting down the OS.
CLIENT MAC ADDR: XX XX XX XX XX XX
To Next Page
Loading...
