www.profireenergy.com
© 2015 PROFIRE
C | Resetting to Defaults
The system settings can all be reset to factory defaults by following these instructions:
1. Make sure that the system is stopped.
2. Navigate to the “Reset to Factory Defaults” menu item at the
bottom of Menu 4.
3. Use the Arrow keys to change the setting to “Yes” and then
press the OK key.
4. The system will display “Parameter Saved” and will then
reboot.
5. After rebooting, the system will display the message
“CONFIGURATION RESET TO DEFAULT” alternating with “Check
Settings and Setpoints.”
6. Press the OK key to acknowledge this warning.
This process only resets the user settings back to factory defaults and does not affect the calibration
settings. To reset the calibration settings to defaults, refer to the Field Calibration section.
Note that older versions of firmware did reset both the user settings and the calibration settings to
defaults. Also note that all settings are stored on the Door Card. If the Door Card is replaced for any
reason, the settings will need to be re-entered and calibration may need to be performed.
FOR ANY QUESTIONS PLEASE VISIT OR CALL US.
www.profireenergy.com | 1.855.PRO.FIRE
To Previous Page
Loading...
