Prolitec AirQ 1570 User Manual

AQ1570 13Chapter 5 Installation
CCU Installation
1. Place the CCU enclosure onto the desired location on the wall and ensure that it is level.
2. Fasten the CCU to the wall using the appropriate screws for the wall material.
3. Connect the power cord to a nearby outlet.
Cartridge Unit Installation
1. Place the cartridge unit enclosure onto the desired location on the wall and ensure that it is level.
2. Fasten the enclosure to the wall using the appropriate screws for the wall material.
3. Assemble the plume kit according to the included instructions.
4. Attach the additional 6-inch segment of injector tubing to the plume bulkhead on the exterior
of the enclosure. The tubing should be directed away from the wall or other surfaces.
Airline Tubing Installation
1. Connect the CCU enclosure to each cartridge unit enclosure by pushing the airline tubing rmly
into the appropriate push-to-connect bulkhead ttings (Fig. 1). If you need to disconnect the
tubing from the bulkhead ttings, depress the grey ring as shown in Fig 2.
Fig. 1 Fig. 2
2. Excess tubing length may be cut or coiled and secured with zip ties.
3. Airline tubing should be hung in a way that protects it from damage and secured to the walls
or ceiling with cable loop clamps or cable raceway as necessary.
5

Prolitec AirQ 1570 Specifications

Power

input voltage	100 – 240V AC
input current	1.5A max
frequency	50/60 Hz
internal power	15VDC at 4 A
battery type	Lithium 3V, #CR2032

Operating Environment

working temperature	0˚ to 40˚ C
working humidity	85% or less
service area per cartridge head	Up to 150, 000 cu. ft. (4245 m³)

Capacity

liquid capacity	2500mL cartridges

Weight and Dimensions

CCU dimensions	36cm x 35cm x 17.2cm
cartridge head dimensions	35.6cm x 18cm x 17.2cm
CCU weight with 4 modules	12 lbs (5.1 kg)
cartridge head weight	5 lbs (2.5 kg)