PATHWAY
®
MR-20 OPERATOR’S GUIDE
50
CHAPTER 3: TROUBLESHOOTING
STORAGE
1. Store your Pathway
®
EMG device in the carry pouch provided to keep the device
safe, dry, and clean.
2. Detach and discard electrodes from the Pathway
®
Preamplier (Part #2583) when
not in use. Not detaching electrodes after use can damage the Pathway
®
Preamplier (Part #2583).
3. Unplug and detach all Pathway
®
Preamplier cables from the Pathway
®
MR-20
device when not in use. Cables can be unplugged from the Pathway
®
MR-20 by
gently pushing on the plastic connector thumb tab and gently pulling cable out of
device.
4. To extend cable life, it is recommended to:
A. Hang all cables by plastic connector
B. Loosely coil cables
C. Wrap the cables as they came (a total of 7 times) after each use. DO NOT TIE
OR TWIST CABLES AFTER USE.
5. DO NOT leave the battery installed when the device is stored for long periods of
time. This can cause damage.
6. Turn the device off at the end of each session.
PATHWAY
®
MR-20 CARE AND MAINTENANCE