If an Access protect is then set after 1 minute a padlock
will appear instead of the " i " in the top left of the contin‐
uous display if in the meantime no key has been
pressed.
8.7.4.2 Password
In this menu enter the number you want to use as a password.
The password applies for both locks.
8.7.4.3
Using Access protect and Password
To test whether the menu is locked, press the
[P/OK]
key for 2 s.
If you try to change into a locked area, a
„Password“
request appears.
To override the Access protect, enter the
„Password“
using the
[arrow keys]
and press the
[P/OK]
key.
In the stroke adjustment dial has been turned, the padlock flashes, the
pump stops and a fault alert and key appear. If you enter the code, the
pump continues metering and the fault alert clears.
8.8 Information about the pump (INFORMATION menu)
Continuous
display
Software version
DATA: 00.03.06.03
HMI: 01.00.00.07
CTRL: 00.03.05.05
FC: 00.01.08.03
PFC: 00.00.03.00
Main menu
Mode
Settings
Service
Information
Language
Information
Identcode
Serial number
Versions
End
Versions
Software version
Hardware version
End
ESC
In the "Info" sub-menu you can read off the following identification num‐
bers:
n Identity Code
n Serial number
n Software versions
n Hardware versions
8.9 Set language (LANGUAGE menu)
Language
Main menu
Settings
Service
Information
Language
End
German
English
French
Spanish
Continuous
display
Test
Overriding the Access protect.
Changing the stroke length variable
Setting
62
To Next Page
Loading...
Need help?
General
