Edge
TM
Multipoint and Quickbridge - Hardware Installation Guide 18
5
Device Link Establishment
Antenna alignment is the process of physically aligning the antenna of the radio receiver and transmitter to establish a link
between two point-to-point devices with an optimal throughput. The antenna alignment process is usually performed during
the installation of the antennas. Refer to section 7.2.6.1 Antenna Alignment using CLI Commands.
5.1 Alignment with RSSI LEDs
RSSI LEDs helps to align/adjust the antennas such that the signal between the devices is optimal. The number of RSSI LEDs
which glow as per the signal level are as below:
To Next Page
Loading...
Need help?
General
