All rights reserved Page 15
Step 8: Mount the Unit
To pole-mount the unit, insert the provided screws through bracket F.
Fasten around the pole to bracket E and secure (Torque 11 N
.
m/100 in-
lbs).
To wall-mount the unit, mount bracket (E) to the wall using 4 screws (not
provided), as shown:
Note:
At the end of the installation, the Ethernet and serial ports must be made
weatherproof by installing the caps. Be careful not to over-tighten the caps
as damage to the cable may occur.
1.
2.
To Next Page
Loading...